Making a bench to accommodate more people at the dining table. Didn't have much time so went for a very basic design.
Material: 2"x2" (approx) pine for the legs and 3/4"x4.5" pine from pallets for the top.
Joined 3 planks of 4' each with dowel joints to make the top.
For the legs, all are basic butt joints but added pocket screws for bit more strength. The pocket screws are from aliexpress so have a philips drive rather then the square one that Kreg has. However, they stick out a bit over the top of the piece so i had to make matching divots on the underside of the top piece so it would sit properly.
There were a couple of holes in the top which I filled with clear epoxy resin.
Finishing: Asian Paints White Satin on the legs and Asian Paints Touchwood 1KPU for the top






